THE SHORT ANSWER
Estimate faucet replacement by product selection, existing access and connection readiness. Keep the fixture allowance, removal and connection parts separate so the customer can see the assumptions behind a small plumbing job.
This guide follows a fictional one existing-sink faucet change in Kelowna, British Columbia. The linked kitchen faucet replacement PDF example shows the scope and 7 separate costs in Canadian dollars. Treat it as a worked document, then use measurements, supplier quotes and labour inputs from your own project.
1. Record the fixture and sink
Confirm mounting-hole configuration, clearances and selected faucet before pricing a final installation. Product fit is more useful than a generic faucet count.
2. Inspect access under the sink
Crowded cabinets, damaged shutoffs or corroded connections may change the work. The example assumes usable existing connections and treats repairs as a scope change.
3. Identify material responsibility
State whether the contractor buys the faucet and which small connection parts are allowed. If the owner supplies it, remove or adjust only the material allowance.
4. Finish with a defined check
List a visible connection and operation check plus cleanup. Do not roll a broader plumbing-system diagnosis into a faucet swap without a separate description.
Review the Canadian project address
For the one existing-sink faucet change in Kelowna, British Columbia, the example uses the measured trade units shown in its PDF. Residential jobs may mix square feet, linear feet, counts and supplier units; keep each line’s measurement basis visible. Confirm the existing connections and equipment details on site. Identify any licensed trade work, approvals and inspections needed for the actual address without assuming the sample covers them. The figures are fictional CAD inputs, not a local price survey.
Describe which products the customer supplies and which the contractor supplies. State how any site condition outside the visible scope will be assessed and priced. Do not copy an allowance from another city or assume a sample’s tax entry establishes the treatment for this client.
Work through the kitchen faucet replacement quantities
The matching PDF lets the client check each extension of quantity and unit rate. For this example, two useful checks are:
- Existing faucet removal: 1 each × C$106.00 = C$106.00.
- Faucet product allowance: 1 each × C$335.00 = C$335.00.
Adding all 7 lines gives a C$974.00 illustrative subtotal. The PDF records 0% tax and C$974.00 as its total, before any markup. These are chosen sample inputs, not prices observed in Kelowna, British Columbia. The measurement basis matters as much as the rate: a material purchase allowance may be larger than the installed area, while a fixture count is not interchangeable with hours of labour.
Check the scope before sending
- Confirm mounting compatibility.
- Inspect access and existing shutoffs.
- Identify faucet supplier.
- State leak-check and repair boundaries.
Outside the illustrated scope: No sink replacement, shutoff repair, supply relocation, drain alteration or concealed water-damage repair.
Check the business and client names, property location, dates, quantities, unit rates and notes. Confirm tax, markup and any required approvals for the actual job. If selections or site conditions are unresolved, label the line as an allowance and explain how it will be updated.
Common questions
Can I quote a faucet without a model?
Use a labeled product allowance for an early estimate, then verify the selected model against the sink before finalizing the scope.
Are new shutoffs included?
Only if listed. This example assumes the existing shutoffs are suitable and prices any repair separately.
Open the itemized kitchen faucet replacement example and its app-exported PDF to see these decisions presented to a client. You can adapt the structure while replacing every fictional project input with your own.
